What precautions should be taken when replacing the Bucket of the excavator?

SK450 Rock Sieve Bucket is one of the most frequently used parts of the excavator. Similarly, the bucket is also the fastest-wearing component and requires frequent replacement of the bucket of the excavator. The replacement of an excavator bucket is a technical task that requires operators to pay attention to in order to complete the operation without damaging the machine and injuring people. As an Excavator Adapter Manufacturer, what are the precautions for replacing the excavator bucket?

1. When hitting the pin with a hammer, metal filings may fly into the eyes and cause serious injury. When doing this, always wear goggles, hard hats, first gear and other protective gear. Protect yourself before you proceed.

2. When unloading the bucket, place the bucket stably.

3. Strike the pin hard, the pin may fly out and hurt the surrounding staff.

4. When disassembling the pin, pay special attention not to stand under the bucket, and do not place your feet or any part of your body under the bucket. When removing or installing the pin, be careful not to hurt your hands.

5. When aligning the holes, do not put your fingers into the pinholes.

6. Before changing the bucket, stop the machine on a solid and level ground. When performing the linking work, for safety reasons, and the oil pipeline personnel who are performing the linking work must understand each other's signals and work carefully.

The above six points are the precautions for replacing the excavator bucket. Do not observe the above precautions in actual operation, and cause personal injury or death, and you will lose more than you pay!

Caterpillar Bucket Teeth Maintenance Tips:

The bucket teeth are also part of the daily maintenance of the excavator. It is an important part of the work, so we must spend a few minutes every day to check the bucket.

The inspection content is the degree of wear of the bucket body and whether there are cracks, if the degree of wear is more serious, you should consider strengthening. As for the bucket body with cracks, welding repair should be carried out in time to avoid increasing the length of the cracks due to delayed repairs, which will lead to unmaintainable situations. In addition, kick the bucket teeth with your foot to check whether the bucket ruler is stable. If the bucket teeth are loose, you should tighten them immediately.

So bucket teeth are teeth of excavators. It is the terminal of the working device of the excavator. During the excavation operation, the bucket tooth is the working part with the largest load and belongs to consumable parts. Especially in the stone construction environment, the bucket tooth wears particularly fast. The use of bucket teeth can actually affect the working efficiency and production cost of the excavator. When the tip of the bucket teeth is relatively worn, the force required for the excavator to cut in during the digging operation will inevitably increase, which will result in greater fuel consumption and affect work efficiency. Therefore, when it is detected that the tooth loss is serious, it is necessary to replace it with a new tooth in time.