What Are The Common Faults Of Cutting Plotter?

The uses of Cutting Plotter include: clothing leather, medical packaging, nameplates, craft gifts and other materials and industries. It is more suitable for applications that require more precise and higher precision.

Cutting Plotter

We may encounter faults in the process of using the cutting plotter. What are the common faults of the cutting plotter and how can we solve them? The following Cutting Plotter Manufacturer will come to tell you.

1. Why is the word engraved and lighter?

(1) The knife holder or pen holder is not clamped, so that the knife holder gradually slides upward during the engraving process.

(2) The carving knife is not inserted in place in the knife holder; so that it is retracted while carving, the more the carving is shallower.

2. During the operation of the plotter, it suddenly stopped. Pressing the up, down, left, right, or offline buttons on the panel did not respond or doodled during the operation.

Analysis and exclusion methods:

(1) Reinstall the software and output the same file test. Pay attention to whether any error message appears during the installation. If so, consider reinstalling the operating system.

(2) Replace the data cable.

(3) If this is not the case, there may be a problem with the memory chip on the motherboard. Open the bottom cover and replace the chip or motherboard.

3. What should I pay attention to when engraving small print?

(1) The speed should be adjusted to the slowest.

(2) The knife tip should not be extended (preferably a new knife with an extension of 0.5mm).

(3) Add sharp angle compensation to the output software. The compensation is generally between 0.30 and 0.50 (setting the compensation value can ensure that the small characters below 2 cm will not be deformed).

4. What to do if the lettering is dislocated or deformed?

Analysis and exclusion methods:

(1) Check if the hex screws on the paper feeding stick are loose.

(2) If it is still misplaced, open the left case and check the hexagonal screws on the timing wheel and whether there are cracks on the timing belt. If there is a problem, replace with new screws or replace the timing belt.

(3) Check if the pressure of the pressure roller is uniform. If the strength is not uniform, replace it.

5. What should I do if the carved characters overlap?

Analysis and exclusion methods:

(1) Open the right case and check whether the right motor synchronous wheel is detached from the shaft. Use 502 glue to stick it firmly.

(2) Check the timing belt for cracks or abrasion, and replace it if necessary.

6. What should I do if the lettering feed roller does not move?

(1) Check if the motor is burnt out. If it is burnt out, replace the main board and motor, and check the voltage of the power supply board.

(2) The paper stick is jammed by the paper or the paper stick bearing is broken, it must be sent to the factory for repair.

7. Why is the plotter not outputting?

(1) The cable between the plotter and the computer is not connected properly.

(2) The port setting of the plotter is incorrect, or there is a problem with the serial port of the computer's motherboard.

(3) The model of the plotter is not selected correctly when engraving.

(4) The plotter is not online.

The above are the common faults and solutions of the lettering machine introduced by Business Card Cutter Supplier. Hope to help you.