Φ610 Induction Bending Machine

Φ610 Induction Bending Machine

Product introduction

Mechanical Design:

Solidworks And FEA Software design .

Control System:

SIEMENS PLC HMI SCADA.

Hydraulic System:

Solidworks

Induction Heating System

IGBT or SCR .

7×24 Hours After Service

The induction bending machine is suitable for oil, natural gas, chemical, electric power, construction, and other industries.

The bending machine principle adopts induction heating and hydraulic cylinder pushing.

The material of the pipe: carbon steel, alloy steel, stainless steel, etc.

It is used for hot bending of various round steel pipe or square steel pipes, angle iron, channel steel, and I-beam.

Steel pipe diameter range.

Steel pipe wall thickness range.

The bending radius is generally 2.5D--6D. Any large radius can be bend according to customer needs. Also can produce steel pipes with multiple curvature radius.

The bending angle is generally 0-90° or 0-180°

Equipment structure，

Induction heating power supply part including induction heating power supply, cooling water circulation system, operation cabinet (touch screen, PLC control system).

Hydraulic system: oil tank, pump station, hydraulic cylinder, oil pipe.

Mechanical body: hydraulic cylinder support, push plate, Chassis, platform, transformer support, slide rail, rocker spindle, clamp, etc.

How to use the induction bending machine correctly?

1. First, turn on the power, turn on the switch on the control panel, and then start the oil pump, so you can hear the sound of the oil pump rotating. (The machine does not operate at this time)

2. Stroke adjustment, you must pay attention to adjusting the stroke when using, and be sure to test before bending. There must be a gap of plate thickness when its upper die descends to the bottom. Otherwise, it will cause damage to the molding machine. The stroke adjustment also has an electric quick adjustment.

3. For the selection of induction bending machine notches, a notch with a width of 8 times the thickness of the plate is generally selected. If you bend a 4mm sheet, you need to choose a slot of about 32.

4. The back gauge adjustment of the CNC induction bender machine generally has electric quick adjustment and manual fine adjustment, the method is the same as that of the shearing machine.

5. Step on the footswitch to start bending. The CNC bending machine mold is different from the plate shearing machine. It can be released at any time, release the foot to stop, and then step on to continue downward.

Technical parameters

1. Production Range :OD60---2000mm(2---80 Inches)

2. Radius:1.5D≤R

3. Thickness:2mm--120mm

4. Angle:0--180 degree

5. Material:Carbon steel ,Alloy steel ,Stainless steel ect.

More information please click here.