What are the Causes and Solutions of Linear Vibrating Screen?

As a Vibrating Screen Manufacturer, share with you. The linear vibrating screen can realize multi-layer screening when sieving materials, so the materials can be classified. So what are the reasons and solutions for the mixing of Linear Vibrating Screen during the screening process?

1. Use only for a long time to cause damage to the screen

It is necessary to check the screen of the linear vibrating screen frequently, and the inspection and maintenance of the screen are also mentioned in the daily maintenance of the linear vibrating screen. Therefore, when you use the linear vibrating screen for a long time, you must do a good job of inspection and maintenance. maintain. If damaged, replace the screen.

2. The sealing strip is not tight

When the linear vibrating screen is found to have mixed materials, the seal condition of the screen frame and the screen frame, the screen frame and the screen body should be checked in time. If the seal is not tight, it is recommended to use a sealing strip to seal or replace the screen frame.

3. The motor excitation force is too small

Whether the motor excitation force is too small and the excitation force is too small may cause incomplete screening and small and large materials cannot be completely classified. This situation is mostly caused by the longer use time of the vibration screen motor or the replacement of the motor. Adjust the exciting force of the motor or replace it with a new one!

4. The damage of the grid

There are different types of linear vibrating screens. The wooden screens will be damaged due to vibration in long-term use. The classification of materials will cause the phenomenon of mixing the linear vibrating screens through the damaged screens. Everyone must pay more attention to observation when using the linear vibrating screen.

Linear vibrating screens are widely used in various industries. Before use, we carry out various checks to ensure that the linear vibrating screen can operate normally. Install the linear vibrating screen in strict accordance with the installation and operation instructions. The preparations required before installation are as follows: check whether the motor power meets the requirements, whether the surface is damaged, whether the motor bearings are elastic, and whether the motor screws are tightened. The angle of the weight of the vibration motor can be adjusted according to the specific gravity and the output of the screened material to meet the production needs.

The linear vibrating screen should be installed on a flat floor and, if necessary, on a ground screw. Check if the power supply is out of phase or leaking, and run for 3-5 minutes without load. The power source is the power source of the vibration motor. If the power fails, the device will not work. Therefore, check the power supply carefully and find the problem in time.

Our company also has Vibrating Feeder for Hopper on sale, welcome to consult.