What Are The Reasons For The Heat Resistant Conveyor Belt Bending?

As a Fabric Conveyor Belt Manufacturer , let's talk about why the Heat Resistant Conveyor Belt is bent and its solution.

The Heat Resistant Conveyor Belt has a tortuous curve. The cause of the tortuousness is due to the cause of the equipment, and there are also operational reasons. It is important to accurately analyze the cause of the occurrence. When the tortuosity occurs, first check whether the three holders of the flat vulcanizer are in a straight line. In particular, it is necessary for the nylon core and the E core to have a secondary cold setting. If the clamping viewpoint of the primary stretching and the secondary cold stretching is not 90 degrees, a bending band is often formed. Therefore, the operator may have a misalignment when stretching, or the gripper may have a loose side and may form a bent band. In addition, the thickness difference of the strip blank is missed, and the thick side is thin, and the thick side is vulcanized. The tightening is slightly longer than the thin side. When each board is piled up, the strip is thick and the side is short, and the thin side is short. , thus forming a twist. When the raw tape is vulcanized, if it is placed in the mold frame, it may be deflected, and there may be a bent band.

Solution:

1. As far as possible, the forming process should be staggered by the side of the canvas with the edge of the cloth. The side by side should be elastic and the raw belt should not be thin and thick.

2. When vulcanizing, the raw belt should be squared and cannot be deflected.

3. Always check the operating point of the three grippers in the front, middle and rear, and whether the hydraulic pressure of the clamping is common, is there a loose side and a tight appearance.

4. Timing the plate to reduce the error.

Huayue offers a variety of industrial conveyor belts such as PVG Conveyor Belt , Fire Resistant Steel Cord Belt and EP Nylon Conveyor Belt. Welcome everyone to come to consult and order.