What is the Debugging Method of the Dispenser?

The automatic dispenser has been developed in the country for more than 10 years. Many electronic products have been transformed from traditional manual manual dispensing to automatic dispenser equipment. This is the trend of the development of industrial intelligent production, because the automatic dispenser Compared with the previous manual dispensing equipment, it not only improves the dispensing speed and efficiency doubles, but also has higher stability when handling glues with different viscosities. It can achieve the same amount of dispensing each time, so it is greatly Reduced dispensing production costs. Therefore, one of the skills that many workers in the dispensing processing plant must possess is to operate the automatic dispensing machine. If debugging the dispensing machine becomes a thing for them to think about, after all, the effects of different people operating on the same dispensing machine will bring about effects There is a big difference.

Glue Dispensing Machine with PCB Board

So today Automatic Coating and Spray Machine Wholesale will share the debugging method of the dispenser. In fact, as long as you have grasped the following 6 points in the debugging method of the dispensing machine, you are more proficient in daily dispensing work than the person who can only hold the handle and simply press it, becoming a true expert in dispensing technology.

1. Pressure setting of the dispenser

In the production of daily dispensing processing, you should observe the viscosity of the glue, the environment of the production workshop, and the temperature to set the pressure. If the temperature is too low, the viscosity of the glue will increase and the fluidity will deteriorate. At this time, you need to increase the pressure value, and vice versa. The amount of glue is supplied by the automatic dispenser controller to the hose and needle. The pressure determines the amount of glue and the speed of dispensing. Strong pressure can easily cause the glue to be sprayed and the amount of glue will be too much, which will affect the product. Aesthetic appearance; weak pressure will cause uneven dispensing and leaks, which will affect product quality issues.

2. Dispenser needle

The inside diameter of the Glue Dispensing Machine with PCB Board needle should be selected and 1/2 of the diameter of the glue point. In the automatic dispensing machine work, you can choose a suitable dispensing needle according to the size of the product, different products need to use a suitable needle. The minimum dispensing volume of the automatic dispensing machine is 0.005ml less than the standard volume. The minimum inner diameter of stainless steel needles is 0.1mm, and the minimum inner diameter of needles is 0.1mm. Special attention: the relative height of the dispensing needle to the pcb circuit board and the inner diameter of the needle are the most critical main parameters, so it must be considered when selecting the needle.

Our company also has RO Membrane Making Machine on sale, welcome to consult.