The Reason Why The Ribbon Mixer Generates High Temperature During Operation

The Ribbon Mixer Machine has the advantages of uniform mixing, no dead angle, fast discharge, no surplus, large capacity, stable operation and simple maintenance. The high-fine material or semi-fluid material adopts manual butterfly valve or pneumatic butterfly valve. A heating or cooling jacket can be configured. The heating method is electric heating and heat conduction oil heating. The cooling process can directly inject cooling water into the jacket, and the powder material adopts a pneumatic large opening structure. The jacket has a large heat exchange area and a fast cooling rate.

Ribbon Mixer Machine

When the ribbon mixer is used for a long time and high speed, it will cause a lot of heat. This kind of heat is also harmful to the ribbon mixer itself, and it will also form common mechanical failures. The user cannot be negligent. What is the cause of the high temperature during the operation of the ribbon mixer? The manufacturer of the Double Cone Powder Mixer will give you a detailed introduction.

Many users have used the ribbon mixer to reflect that before the hydraulic excavator heatstroke, the starting work and speed are normal. After one or two hours of operation, the equipment will stop and the excavation will be weak. In some cases, the engine smokes, and then it is dry. At the moment, the most important job is to stop the equipment and cool it to continue the work, which can reduce the efficiency of the work.

As the component wear temperature rises and the internal leakage is added, the function of the hydraulic pump to adjust the system will decrease, and the variable function of the pump will be reduced, and the engine load will be added, and the operation or the flameout cannot be performed normally.

Find the reason for the high temperature of the ribbon mixer, so that you can deal with this problem from the source. Especially in the high temperature presented during the operation, it is more necessary to deal with this problem. So that the equipment can work normally when the work is in operation, and there will be no problem. In addition, the maintenance of the ribbon mixer can also reduce this non-situation to a certain extent. For many users, the cleaning of equipment is often overlooked. Regular cleaning of the equipment not only greatly increases the efficiency of the equipment, but also extends the useful life of the equipment. The cleaning of the ribbon mixer is not a simple and random cleaning, but also a choice of methods.

When cleaning the ribbon mixer, you need to choose the appropriate cleaning oil. If the piping system is very clean, or you just bought it, you can use the viscosity of the cleaning oil and working oil to clean it. But if the system is not very clean, then you can choose a cleaner oil with a lower viscosity. When cleaning with cleaning oil, there are many steps. It must be carried out in strict accordance with the procedures, otherwise it should not be cleaned. When cleaning oil is selected, the cleaning oil should be heated first because the oil can be cleaned after heating. Normally, it is heated to about 50 degrees, but the oil is immediately placed in the device.

In daily use, if the equipment fails, the user should perform maintenance work, including:

1. Pay attention to maintaining the outer body of the ribbon mixer and regularly remove dirt and obstacles.

2. The ribbon mixer should idle for 1-2 minutes before daily operation and check the reliability of the clutch and brake on the machine.

3. Regularly check the oil, circuit and control equipment of each lubrication part. In order to prevent equipment from aging, it is necessary to add lubricant as required.

4. During the operation of the equipment, listen to the noise of the motor, reducer and transmission gear. Is the temperature rise too high? If there is any problem, stop the operation immediately for maintenance until it can be returned to normal operation.

The above is the description of the v Type Powder Mixer supplier about the high temperature of the ribbon mixer. Have you learned?