Precautions For Laying Drip Irrigation Tape

In order to better protect the integrity of the crops, people choose to use drip irrigation tapes for irrigation when they are irrigated. The use of farm drip tape will not cause damage to the crops, and it will drop evenly around the crops drop by drop. Soil, so that the crop soil is often maintained at a suitable humidity, and the use of this equipment will better help us save water and fertilizers, but the premise of the product can play a corresponding role is to lay the equipment When laying, you need to pay attention to the following items, and then make the drip irrigation belt (Dripline) play a corresponding role.

Farm Drip Tape

1. Keep the labyrinth side facing upward (that is, the embossing protrusion side is facing up) when laying the drip irrigation tape.

2. When laying equipment, if the machine is laid, the pulley and the rotating mechanism must place bearings to ensure that the pulley can rotate flexibly, and the equipment cannot be pulled to prevent the labyrinth from deforming and affecting the amount of dripping water.

3. After the installation of the system, water should be supplied to the drip irrigation system in time to prevent sunlight and ultraviolet rays from exploding to accelerate the aging of pipes and equipment.

4. During installation, the staff should read the instructions for each component carefully, and connect the components with the correct installation method.

5. The land on which the drip irrigation equipment is installed must be ground finely and the root stubble must be picked. Stubble, stones, weeds, etc. can easily puncture drip irrigation belts and hold up the mulch, causing water vapor to accumulate in the mulch, forming a lens effect.

6. After the installation of the drip irrigation equipment is completed, a special person should be arranged to manage it. It is strictly forbidden for others to disassemble and open the valve.

7. Once the dry, branch, and attached pipes are installed on the plot, the rigorous agricultural machinery and agricultural tools are rolled and scraped against the pipeline to avoid external force damage and reduce the service life.

8. After the dirt in the filter accumulates, the loss of overcurrent increases. When the pressure difference between the two ends of the filter is 0.2-0.3MPa, it needs to be cleaned.

9. Drip irrigation tape can be buried shallowly when laying to avoid focal burns. A layer of soil about 1 mm thick can also be placed on the device or on the ground film to destroy the formation of the lens and avoid burns.

10. After the drip irrigation is completed, the stem, the supervisor and the connection parts should be recovered and stored for reuse next year.

11. Irrigation should be carried out strictly according to the rotation irrigation group, otherwise, it may cause uneven water discharge or poor pump operation, resulting in waste of energy, which cannot achieve the purpose of saving water, electricity, fertilizer and labor.

12. Regularly open the end of the drip irrigation line and rinse the dirt in the drip tube.

Drip tape manufacturer believes that: Economic drip tape can effectively reduce the water resources for irrigation, so in addition to following the correct operation steps when laying equipment, it is necessary to add more Pay attention to the above matters, and then ensure that the equipment can be used normally during the use process, and will not malfunction. Of course, the corresponding anti-corrosion work must be done during use to prevent the equipment from being corroded for some reasons.