Matching And Use of Bearings

As an Auto Parts Wheel Bearing Factory, let's talk about the fit and use of bearings.

Matching of bearings:

First, the choice of cooperation

The inner and outer diameters of the rolling bearing are manufactured to standard tolerances. The tightness of the bearing inner ring to the shaft and the outer ring to the seat hole can only be achieved by controlling the tolerance of the journal and the tolerance of the seat hole. The inner ring of the bearing and the shaft are matched by a base hole, and the outer ring of the bearing and the seat hole are made by a base shaft.

The correct choice of fit, you must know the actual load conditions, operating temperature and other requirements of Wheel Bearing, but it is actually very difficult. Therefore, most of the cases are based on the use of lint selection.

Second, the load size

The amount of over-win between the ferrule and the shaft or casing depends on the size of the load. The heavier load uses a larger over-win, and the lighter load uses a smaller over-win.

Wheel Bearing

Precautions for use:

Rolling bearings are precision parts, so they need to be cautious when using them. Even if high-performance bearings are used, if they are not used properly, the expected performance will not be achieved. Therefore, the following matters should be noted when using bearings:

1. Keep the bearings and their surroundings clean. Even very small dust entering the bearing can exacerbate bearing wear, vibration, and noise.

2. Careful and careful when installing, do not allow strong stamping, can not directly hit Wheel Bearing Parts, and do not allow pressure to pass through the rolling elements.

3. Use the correct installation tools, try to use special tools, and try to avoid the use of cloth and short fibers.

4. Prevent the corrosion and rust of the bearing. It is best not to take the bearing directly with the hand. Apply high-quality mineral oil and then operate it. Pay special attention to rust prevention during the rainy season and summer.