Do you know the correct maintenance method for Fabric Laser Cutting Machine?

Many customers do not understand how to maintain and maintain the machine when it ages. When it is used, the Fabric Laser Cutting Machine Factory now popularizes some methods for laser machine maintenance and maintenance:

Fabric Laser Cutting Machine

1: water tank cleaning and water tank cleaning

Recommended: Clean the water tank and replace the circulating water once a week

Note: Make sure that the laser tube is filled with circulating water before the machine works.

The quality and temperature of the circulating water directly affect the life of the laser tube. It is recommended to use pure water and control the water temperature below 35 ° C. If the temperature exceeds 35 ℃, the circulating water needs to be replaced, or ice cubes can be added to the water to reduce the water temperature. (It is recommended that users choose a cooler or use two water tanks).

Clean the water tank: first turn off the power, unplug the water inlet pipe, let the water in the laser tube automatically flow into the water tank, open the water tank, take out the water pump, and remove the dirt on the water pump. Clean the water tank, replace the circulating water, return the water pump to the water tank, insert the water pipe connected to the water pump into the water inlet, and arrange the joints. Power on the pump separately and run for 2-3 minutes (make the laser tube full of circulating water).

2: Fabric Laser Cutting Machine Cleaning

Long-term use of the fan will cause a lot of solid dust and debris to accumulate inside the fan, which will cause the fan to generate a lot of noise, which is also not conducive to exhaust and deodorization. When the suction power of the fan is insufficient, the power will be turned off, the air inlet and outlet pipes on the fan will be removed, the dust and debris inside will be removed, and then the fan will be turned upside down and the blades inside will be pulled out. Clean with a rag and install the fan.

3: Lens cleaning

(It is recommended to clean before work every day, the device must be turned off)

There are 3 mirrors and 1 focusing mirror on the engraving machine (No. 1 mirror is located at the exit of the laser tube, which is the upper left corner of the machine, No. 2 mirror is located at the left end of the beam, and No. 3 mirror is located at the fixed part of the laser head Top, the focusing lens is located in the adjustable lens barrel at the bottom of the laser head). The laser light is reflected and focused by these lenses and emitted from the laser head. The lens is easily contaminated with dust or other pollutants, causing laser loss or lens damage. Do not remove the lens 1 and 2 when cleaning, just carefully wipe the lens cleaning paper dipped in the cleaning solution toward the center of the lens. Edge swivel wipe. The No. 3 lens and focusing lens need to be taken out of the frame, wipe it with the same method, and then replace it as it is.

Note: 1. The lens should be wiped gently to avoid damaging the surface coating; 2. Handle gently during the wiping process to prevent falling; 3. Be sure to keep the concave side down when installing the focusing lens.

4: The cleaning of the guide rail

(Recommended cleaning once every half month, shutdown operation)

The guide rail and linear shaft are one of the core components of the equipment and their functions are to guide and support. In order to ensure the machine has a high processing accuracy, it is required that the guide rails and straight lines have high guiding accuracy and good motion stability.

We also have Heavy Duty Laser Cutting Machine on sale, welcome to consult.