Precautions for Blow Molding Machine Operation

Precautions for Blow Molding Machine Operation

Blow molding machine brands continue to emerge. According to preliminary statistics, there are nearly 100 blow molding machine manufacturers in China. The operation interface of blow molding machines produced by different manufacturers has different degrees of differences. In order to facilitate the industry to have an in-depth understanding of the blow molding machine, the following is a brief introduction to the considerations in the operation of the blow molding machine.

Automatic Multi Layers Extrusion Blow Molding Machine Special For Cosmetic Bottles

1. Without professional training personnel can not operate the blow molding machine.

2. Before starting the machine to ensure that the machine is grounded to zero, so as not to leak electricity to cause unsafe accidents.

3. Before heating the blowing machine, check carefully whether the cooling water of each part is connected.

4. Before running the automatic bottle blowing machine, lift the machine to the proper position to ensure that the machine head does not collide with the template to avoid damage to the equipment.

5. The machine system pressure has been set before leaving the factory. No special circumstances can be adjusted at will, so as not to damage the hydraulic system or affect the normal operation of the machine because the pressure is too large or too low.

Dual Station Blow Molding Machine Special For Plastic HDPE/PP Shampoo Cosmetic Bottle

6. Workers are strictly prohibited to feed on the machine to avoid electric shock or scalding and fall from height. (The machine should be equipped with automatic feeding device).

7. When blow molding machine for mold shifting and mold closing operation, it is forbidden for the operator to enter the safety door area to avoid being pinched or injured.

8. Automatic blow molding machine in normal operation, do not pull the extruded blank by hand, so as not to be burned by high-temperature materials and electric heat knife or be caught by the mold.

9. Be sure to turn off the main oil pump when adjusting the die-shifting and die-closing photoelectric switch to avoid unsafe accidents.

10. In case of emergency, quickly press the red emergency stop button to prevent accidents.