Installation Method of Dumpling Machine

Installation Method of Dumpling Machine

1. Before using the dumpling machine, be sure to read the instructions carefully.

2. Be sure to add one kilogram of engine oil to the gearbox before starting, otherwise it will damage the reducer and shorten the life of the machine.

3. Remove the protective cover of the dumpling machine and check to see if the tightness of the chain is appropriate. The chain should not be too loose or too tight. If it is loose, it will rattle. Check again if the screws are loose.

Small Automatic Dumpling Making Machine

4. Check the drum and powder box of the dumpling machine to see if there are accessories or other sundries in it to prevent the dumpling machine from being damaged when the machine is turned on.

5. Connect the power, start the switch, listen for any abnormal sound, and see if the dumpling machine is running in the forward or reverse direction. If it is in the reverse direction, turn down the power cord and confirm that there is no problem.

6. Check whether the conveyor belt is off to one side after turning on the machine. The handwheel on the other side of the conveyor belt is clockwise. Or loose the handwheel in the opposite direction is counterclockwise, you don't need to adjust it too much, it will not deviate slowly. The conveyor belt should not be too loose or too tight. If it is loose, it will slip, and it will pull the shafts on both sides of the conveyor.

Automatic Dumpling Machine

7. Before adjusting the drum of the dumpling machine, first adjust the handle of the adjusting drum to be very tight, mark it, and release the handle at the same time, so that the thickness of the dumpling produced will be consistent. Then put the prepared dough in the feed port, do not point the hand into the roller to push the surface, use the palm of your hand to avoid pressing your fingers close to the roller to cause injury, repeatedly press the dough into shape according to your needs, and then roll it up with a wooden shaft , And then put it into the feeding port of the dumpling machine, adjust the thickness of the roller you need, you can make smooth noodles, and then conveyed through the conveyor belt, open the powder box clutch to sprinkle the starch or flour automatically, there is a conveyor belt to finish The flour dough is automatically brought to the folding rack, and the dough is automatically folded by the automatic folding device.