Correct use of traction rope

The tow rope is generally used for the temporary towing of the malfunctioning vehicle. Here's how to use the Double Braided Towing Rope

1. Find the position of the trailer hitch behind the towing vehicle and in front of the towed vehicle. The position of the trailer hook of many vehicles is designed in the lower part of the bumper. Generally, the position is clearly marked in the vehicle user manual. The owner can also find hidden spaces by observing the front and rear bumpers. Here, a round or square cover is used to cover it. The location is where the car trailer hitch is located.

2. The trailer hook of some cars is split and needs to be assembled during use. After removing the cover on the bumper, assemble the hook that comes with the car.

3. Install the trailer tool. Regardless of whether you choose a soft or hard trailer tool, you must ensure that it is firmly and reliably connected to the car hook during installation. The tow hook is designed with a safety lock and needs to be locked in place. Check the front and rear connections again before driving the trailer. The soft tow rope without towing hooks on both ends should be tied with a slip knot when in use. If the tow rope is pulled with great traction after the knot is closed, it will be difficult to untie the tow rope.

4. The tractor starts with 1 gear to ensure that the large torque provides sufficient traction. At the same time, the tractor needs to control the speed of the vehicle, maintain a stable driving, and increase the power output when it feels a little resistance. For manual gear models, avoid violently lifting the clutch pedal and start slowly with semi-linkage to avoid damage to the car.

Knotting method of trailer rope

To double-tap, first wrap the rope around the object twice. Then pass the end of the Yitongxing towing rope through the second loop and pull it tightly. At the end, just tie a half knot. To reverse the figure eight knot, first tie a figure eight knot in the middle of the rope and cross the ends of the rope first. Then the rope head goes around the main rope, passes through the rope loop and then tightens. Next, pass the end of the rope along the knot from the opposite direction to the end of the rope, and then pass the end of the rope through the first knot. And go back under the knot. In the process of winding back, you need to pass the end of the rope through the loop below. Finally, adjust the tension.