Preparation and maintenance method before operation of automatic capsule filling machine

Generally speaking, the automatic capsule filling machine is a kind of automatic hard capsule filling equipment with intermittent operation and orifice metering. Precise design and smooth operation. It can automatically complete various processes such as bag spreading, bag separation, filling, waste bag removal, bag locking, and finished product export. In order to maintain the normal and smooth use of the automatic capsule filling machine model, the equipment should be adjusted before it is used again. So what should be done before use.

1. Turn on the power.

2. Check that the settings are properly equipped and adjusted.

3. In the absence of capsules and powder, turn the hand wheel 1-3 times according to the running direction of the machine. Normally, put the capsule and powder into the capsule bucket separately. The height of the powder bucket should be 60mm lower than the height of the container. At the same time, there should be more than half of the powder in the metering and distribution room.

4. Adjust the preset depth of the filling rod into the metering plate.

5. After adjustment, press the main unit to jog, and only after the jog is normal can the switch be started for automatic operation.

6. Speed regulation when the main motor is running.

Tips In order to make the automatic capsule filling machine more efficient and longer, please do these tasks well.

Maintenance precautions:

1. The automatic capsule filling machine is a vibrating machine. The tightening of the screws in each part should be checked frequently. If it is loose, it should be tightened in time. to prevent malfunction and damage.

2. Plexiglass parts (workbench board, medicine board) should avoid direct sunlight, close to high temperature, and do not place heavy objects. Medicine boards need to be placed vertically or horizontally to avoid damage

No deformation and damage.

3. After the end of each day, clean up the residual medicine on the machine and in the die hole, keep the machine clean and hygienic, and avoid washing the machine with water. If the mold on the machine needs to be cleaned, it can be cleaned, loosen the set screw, and then remove. It's easy to install.

4. The oil change of the reducer of the locking machine is 24 hours for one time, and 72 hours for the second oil change. Replace every few months.

The above is the preparation and maintenance method before the operation of the automatic capsule filling machine, I hope to be of some help to you.