Safety Matters For the Use of Mixers

Mixer, a kind of machine with a bladed shaft rotating in a cylinder or trough to stir and mix a variety of raw materials into a mixture or suitable consistency. The Mixer is divided into forced mixer, single horizontal shaft mixer, double horizontal shaft mixer, etc. The mixer is widely used in paint, solid for mixing and dispersing, dissolving efficient equipment, ink, pigments, adhesives and other chemical products, the equipment is composed of hydraulic system, main drive, mixing system, guiding mechanism, electric control box five parts, the structure of each part of the equipment is compact and reasonable.

Double Cone Blender

Use safety

1. The mixer should be set in a flat position, with square wood pad up the front and rear axle, so that the tire shelves high overhead, so as to avoid walking when the start.

2. The mixer should be implemented two leakage protection, before going to work after the power is connected, must be carefully checked, by the empty test run that qualified, before use. Test run should test the mixing cylinder speed is appropriate, in general, the empty speed is slightly faster than the car 2 ~ 3 revolutions, such as the difference between more, should adjust the ratio of dynamic wheel and transmission wheel.

3. The direction of rotation of the mixing cylinder should be in line with the direction indicated by the arrow, if not, the motor wiring should be corrected.

4. Check whether the transmission clutch and brake are flexible and reliable, whether the steel wire rope is damaged, whether the track pulley is good, whether there are obstacles around and the lubrication of each part, etc.

5. After starting the machine, often pay attention to the normal operation of the components of the Double Cone Blender. When the machine is stopped, often check whether the mixer blade is bent, whether the screws are knocked down or loose.

6. When the concrete mixing is completed or expected to stop for more than 1h, in addition to the residual material out of the net, the application of stones and water into the shaking cylinder, turn on the rotation of the machine, the mortar stuck in the cylinder rinsed clean after all unloaded. There should be no water in the barrel to avoid rusting of the barrel and blades. At the same time, it should also clean up the dust outside the mixing cylinder, so that the machinery is kept clean and intact.

7. After work and shutdown, the power should be shut off and the switch box should be locked to ensure safety.

The company also provides Powder Mixer and ribbon mixer, if you need, please feel free to contact us!