What are the Winding Methods of Transformers?

As a Transformer Winding Wire Manufacturer, share it with you.

There are many winding methods for transformers. This article will introduce you to various winding methods for transformers.

Close

Dense winding means that the line and the line are close together, and the lines cannot be layered or crossed in the winding. For example, the second layer is not allowed to appear when the line is tightly wound, and there is no gap between the line and the line. And crossover phenomena.

1. The wiring is even and tight;

2. The cable has no knots, no crosses, no overlaps, and no phenomenon of falling into the next layer from the previous layer.

 Transformer Winding Wire

All around

All winding means that the distance between the wire and the wire is approximately equal, and the entire winding area is wound. The winding wire should be close to the end control tape, but the upper end control tape is not allowed.

1. Winding around the entire winding area;

2. The distance between the lines is roughly equal;

3. The take-up and take-up line is wound by end control tape, and there is no upper end control.

And go around

Two or more wires wind the same set of wires in parallel at the same time, and each wire is parallel. Do not cross. Do not hang the take-up wire on the wrong position. The incoming and outgoing wires must be at right angles.

This winding method can be roughly divided into four situations:

a. In the same group and around;

b. Different groups in parallel;

c. Multiple groups and winding;

d. Different groups or double winding in the same group.

Same layer winding

1. The same layer winding means that two or more windings are wound on the same layer, and each winding is independent of insulation;

2. Winding should be even. When the cable is tightly wound, the cable should not climb on the end control tape. The in and out of the cable should be at right angles. The specific requirements should meet the requirements of the work instruction.

Center winding

1. Center winding is to wind in the middle of the winding area in the skeleton winding area. As shown in the figure, the size of A and B are roughly equal, that is, "A" = "B";

2. The winding should be uniform, and the incoming and outgoing wires should be at right angles. According to the requirements of the operation instruction, use the centered dense winding or the centered winding.

Our company also has Transformer Winding Wire on sale, welcome to contact us.

https://www.cerfdor.cn/news/1235.html