What Failures May Occur During the Debugging and Operation of the Mask Machine?

As a Mask Machine Manufacturer, share with you.

What should I do if there is a problem with the mask machine equipment during the debugging process? Today everyone will solve this problem. Below we enumerate the failures that may occur during the commissioning or use of the mask machine equipment, analyze the reasons, and give solutions, hoping to help everyone.

Face Mask Making Machine

Uneven welding and distortion of the workpiece.

Solution:

1. Check whether the size of the workpiece is different.

2. Check whether the operating conditions cause deformation of the work

3. Adjust the buffer speed or pressure.

The base support is not stable.

Solution:

1. Improve the support point where necessary.

2. The base is redesigned.

3. Replace with a hard base

4. If a large area of the bakelite is inclined, it needs to be reinforced.

The contact surface of the welding head, base, and workpiece is not flat.

Solution:

1. Redesign the energy conservation point to make the height uniform.

2. Adjust the level screw.

3. Check whether the contrived conditions are true.

4. Check the shape and size of the workpiece size.

5. The side is curved, and the workpiece is ribbed

6. Modify the jig to avoid bending the workpiece.

Fault four, the workpiece error is too large.

Solution: 1. Tighten the tolerance of the workpiece.

2. Re-modify the size of the workpiece.

3. Check the operating conditions (pressure, delay timing, welding timing, curing timing, etc.).

Our company also has Face Mask Making Machine on sale, welcome to contact us.