Due to the low efficiency and unstable quality of Hand Taps, in actual mass production, machine tapping threads with good quality, high efficiency and low production cost are mainly used. But in the process of machine tapping, we must also use machines and tools correctly, otherwise, it will also affect the quality of threaded holes.
The radial runout of the drilling machine spindle should generally be adjusted within 0.05mm. If the precision of tapping the threaded hole is high, the radial runout of the spindle should not be greater than 0.02mm. The positioning support surface of the fixture for clamping the workpiece and the center of the drilling spindle The verticality error of the center of the tap should be no more than 0.05mm/100, and the coaxiality between the threaded bottom hole of the workpiece and the Professional Taps should generally be no more than 0.05mm.
Machine Taps
When the Machine Taps is about to finish tapping the thread, the feed should be light and slow to prevent the front end of the tap from interfering with the depth of the thread bottom hole of the workpiece and damaging the tap; when tapping a blind hole thread or a deep screw hole, it should be Use tapping safety chucks to withstand cutting forces.
The cutting force of the safety chuck must be adjusted according to the size of the tap to avoid breaking the tap or failing to enter the tap; within the tapping stroke of the cutting part of the tap, a uniform and appropriate pressure should be applied to the feed handle of the drill press. In order to assist the tap to enter the bottom hole, it can avoid that the thread is scratched when the spindle is pulled down by the first few incomplete threads. When the calibration part enters the workpiece, the thread is reliably screwed in for tapping, so as not to The teeth are cut thin.
When tapping through-hole threads, it should be noted that the calibrated part of the tap cannot be completely exposed, otherwise, the tapping phenomenon will occur when the tap is withdrawn from the reverse direction.
The cutting speed of tapping is mainly determined by the cutting material, the pitch diameter of the tap, the pitch, and the depth of the threaded hole. Generally, when the depth of the threaded hole is within 10-30mm and the workpiece is of the following materials, the cutting speed is roughly as follows: steel v=6-15m/min, quenched and tempered steel or harder steel v=5-10m/min, Stainless steel v=2～7m/min, cast iron v=8～10m/min. Under the same conditions, the smaller the diameter of the tap is the relatively high speed, the larger the diameter of the tap is the relatively low speed, and the larger the pitch is the lower speed.
When tapping threads, the cutting fluid is mainly selected according to the material to be processed, and sufficient cutting fluid must be maintained. For metal materials, emulsion is generally used; for plastic materials, emulsified oil or vulcanized cutting oil can generally be used. If the surface roughness value of the threaded hole on the workpiece is low, rapeseed oil and molybdenum disulfide can be used, and the effect of soybean oil is better. In addition to machine taps, we also have other types of internal thread cutting tools.
Products mentioned in the article:
DIN371 DIN376 Machine Tap, Spiral Point for through hole
Copyright：@2020-2021
Comments Please sign in or sign up to post.
0
0 of 500 characters used