Technical Requirements For Clipper Machine

Shearing machine is a kind of shearing equipment that is widely used in various industries. It can cut steel plates of various thicknesses and some other materials. Commonly used shears are divided into flat shears, rolling shears, vibration shears and Semi-Automatic Clipping Machine. Flat shears are used in large quantities. Shears with a cutting thickness of less than 10mm are mostly mechanically driven, and those with a thickness greater than 10mm are hydraulically driven. Generally use pedals or buttons to cut metal in a single or continuous manner.

Pay attention to when operating the shears:

1. Before work, carefully check whether all parts of the shearing machine are normal, whether the electrical equipment is intact, and whether the lubrication system is unblocked; remove the tools, measuring tools and other debris and corner waste placed on the table and its surroundings.

2. Do not operate the shearing machine by one person. Two or three people should coordinate the feeding, control the dimensional accuracy and take the material, and make sure that one person is responsible for the unified command.

3. Adjust the shear gap of the shearing machine according to the specified shearing thickness. It is not allowed to cut two kinds of sheets of different specifications and different materials at the same time; do not cut by overlapping materials. The cut sheet requires a smooth surface, and it is not allowed to cut narrow sheets that cannot be compressed.

Semi-Automatic Clipping Machine

4. The belt, flywheel, gear and shaft of the Clipper Machine must be equipped with a protective cover.

5. The fingers of the shearing machine operator should keep a distance of at least 200mm away from the scissors mouth and leave the pressing device. The protective fence installed on the shearing trigger cannot block the eyes of the operator and cannot see the cut part. The waste generated after the operation has edges and corners, and the operator should remove it in time to prevent stabbing and cuts.

6. The flywheel, gear, shaft, tape and other moving parts of the shears should be equipped with protective covers.

7. Place a fence to prevent the operator's hand from entering the area where the scissors fall. It is strictly forbidden to pick up waste on the ground during work to avoid being injured by the falling workpiece.

8. It is not allowed to cut hardened materials, and never allow cutting beyond the working capacity of the shearing machine.

If you want to buy, please contact our Clipper Machine Manufacturer