What are the Parts of the Automatic Dispenser?

As an Automated Dispensing Solution Provider, share with you. The full-automatic dispensing machine from traditional manual to fully automated production is a huge breakthrough, which explains the production application of automated equipment well. It is the best embodiment of intelligence, modularization and greenness, which brings convenience to many businesses and saves a lot of resources.

Glue Dispensing Machine with PCB Board

Glue Dispensing Machine basically consists of three parts, which are actuator and control system and drive device. The actuator is composed of manipulator and torso. The control system includes motion control card, offline conversion board, hand-held teach pendant and dial switch , Serial port line, interface line, offline liquid products, offline keyboard and other parts. For the specific structure, please see the introduction below:

The first part of the actuator consists of a manipulator and a torso. The manipulator operates in a straight line during the operation. In order to cooperate with the operation of the manipulator, so-called linear hydraulic cylinders, swing hydraulic gangs, electro-hydraulic pulse charging, servo hydraulic motors, AC servo motors, DC servo motors, and stepper motors are generally used. The torso of the dispenser is the main part of the dispenser, including the arm, power source, brackets for various actuators, etc., all belong to the torso of the dispenser.

The second part is the control system. In order to ensure that the dispensing operation is simpler and more accurate at high speed. The control system of the dispenser is equipped with motion control card, offline conversion board, hand-held teaching box, serial line, interface line, offline liquid product, offline keyboard, thin code switch dispensing program. The advantage of this kind of assembly is that the file is easy to download and convenient for data management.

The next thing to talk about is the third largest component of the dispenser: the drive. There are four main drive mechanisms: hydraulic drive, pneumatic drive, electrical drive, and mechanical drive. Among them, only electric and pneumatic drives rely on the relatively small amount of glue used, the air source is convenient, the maintenance is simple and convenient, and the advantage of relatively low cost accounts for 90% of the total application.

After understanding the composition of the dispenser, it is also necessary to understand the working principle of the dispenser. The dispensing machine sends compressed air into a syringe or a plastic bottle, presses the glue into the feed tube connected to the piston chamber, and uses pressure to perform the dispensing operation. When the piston is on the upstroke, the piston chamber will be filled with glue; when the piston pushes the dispensing needle down, the glue will be pressed out of the needle mouth when it is under pressure. The amount of glue dispensed is determined by the distance that the piston undershoots, and it can be adjusted manually or controlled by programming.

Our company also has Glue Dispensing Machine with PCB Board for sale, please contact us.