What should I do if Dust Appears when the Vibrating Screen is not Operated Properly?

Vibrating Screen is a device that relies on a vibrator to move under the impetus of a motor. It is mainly used in the screening or consolidation of materials. When the heavy-duty vibrating screen is in operation, the vibration intensity is stronger than other types of vibrating screens. Therefore, during the material screening process, the materials can be easily and quickly. As a Vibrating Screen Manufacturer, share with you.

Linear Vibrating Screen

Vibrating screen is a device that relies on a vibrator to move under the impetus of a motor. It is mainly used for screening or vibrating of materials. When the heavy-duty vibrating screen is in operation, the vibration intensity is stronger than other types of vibrating screens, so the materials can be easily and quickly screened during the material screening process. However, if the operation is improper during use, dust is easy to appear. The correct operation of the heavy-duty vibrating screen is the key that cannot be ignored. So what are the operating points of the heavy-duty vibrating screen?

1. Close the power switch and run it for 30 minutes without running. Generally, the motor should run counterclockwise. If the direction is wrong, please adjust the three-phase power supply.

2. Make sure that the vibration motor is running within the rated current. At the beginning of the operation, especially at low temperature, the current will be slightly higher; within 30 minutes, it should be reduced to the rated current.

3. There should be no abnormal sound in the sieve machine. If any abnormal sound occurs, it should be shut down quickly for inspection. The abnormal sound is generally caused by the loosening of the fastening part. Especially when transporting and disassembling and reassembling, pay great attention to the tightening of each part. The sieve has a transient resonance zone when starting and stopping. At this time, the amplitude and noise will increase significantly, which is normal.

4. After dry running, a small amount of material can be entered into the sieve through the feeding port, and then slowly increased to the required and able to withstand the amount of material. At this time, the weight adjustment should be performed according to the discharge situation of the screen. To make the efficiency of the sieve reach a better state.

5. The general materials of this series of sieving machines are not equipped with bouncing ball devices, which can meet the screening requirements. Special materials need to be equipped with bouncing ball devices, which are designed and installed separately. At this time, the no-load noise will increase.

For different application fields, the vibrating screens used are different. Some vibrating screens are used for the screening of some wet materials, and some can be used for the screening of powders. In fact, no matter what type of vibrating screen is used, the cleaning of the screen body should be done well, so that the effectiveness of the vibrating screen can be better exerted to reduce the pollution of other materials to this kind of material.

Our company also has Linear Vibrating Screen on sale, welcome to consult.